The flexibility of gas
lift in terms of production rates and depth of lift cannot be matched by other
methods of artificial lift if adequate injection-gas pressure and volume are
available. Gas lift is one of the most forgiving forms of artificial lift,
since a poorly designed installation will normally gas lift some fluid. Many
efficient gas lift installations with wire line-retrievable gas lite valve
mandrels are designed with minimal well information for locating the mandrel
depths on initial well completion. Technical Data used in the field explained
in petroleum
courses in Rawalpindi.
Highly deviated wells
that produce sand and have a high formation gas/liquid ratio arc excellent
candidates for gas lift when artificial lift is needed. Many gas lift
installations are designed to increase the daily production from flowing wells.
No other method is as ideally suited for through-flow line (TFL) ocean floor
completions as a gas lift system. Maximum production is possible by gas lift
from a well with small casing and high deliverability. Wire line-retrievable
gas lift valves can be replaced without killing a well or pulling the tubing.
Some more details of petroleum
courses in rawalpindi are as under.
The gas lift valve is a
simple device with few moving parts. and sand laden well fluids do not have to
pass through the valve to be lifted. The individual well in-hole
equipment is relatively inexpensive. The surface equipment for injection gas
control is simple and requires little maintenance and practically no space for
installation. The reported overall reliability and operating costs for a gas
lift system are lower than for other methods of lift. The primary limitations
for gas lift operations are the lack of formation gas or of an outside source
of gas, wide well spacing. and available space for compressors on offshore
platforms. Generally, gas lift is not applicable to single-well installations
and widely spaced wells that are not suited for a centrally located power
system. Gas lift can intensify the problems associated with production of a
viscous crude. a super-saturated brine. or an emulsion. Old casing. sour gas.
and long. small-ID flow lines can rule out pas lift operations. Wet gas without
dehydration will reduce the reliability of gas lift operations. TSK Training
for Skills and Knowledge is the best institute in Rawalpindi Islamabad for
Pakistani Students who wants to join oil petroleum courses in
Rawalpindi.
No comments:
Post a Comment